MICRO-EPSILON TIM 160 Manuel d'instructions télécharger pdf (Page 27)

Page 27

Electrical Installation

thermoIMAGER TIM

6. Electrical Installation

At the back side of the thermoIMAGER TIM you will find two connector plugs.

Please connect the supplied USB cable with the left plug.

The right connector plug is only used for the process interface.

Plug for USB cable

Plug for PIF cable

Fig. 15 Rear side of camera with connectors

6.1 Process Interface

The TIM is equipped with a process interface (cable with integrated electronics and terminal block), which

can be programmed via the software as an Analog Input (AI) and Digital Input (DI) in order to control the cam-

era or as an Analog Output (AO) in order to control the process. The signal level is always 0 – 10 V.

Please make sure that the process interface (electronics within cable as well as industrial interface) is pow-

ered separately (5 - 24 VDC).

> With no external power supply the PIF will not work

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 63 64

Pas de commentaire

MICRO-EPSILON TIM 160 Manuel d'instructions Page 27